ENSONIQ OEX-6sr User Manual download pdf (Page 4)

OEX-6sr

Operation Manual

(included) in the position marked by your masking tape.

Remember to remove the masking tape and discard. Then

place the “hook” side of the velcro strips on the bottom of

the OEX-6sr. Use your thumb to apply pressure to all

velcro strips to ensure a secure fit. Keep in mind, that it

could be difficult to remove the velcro from the front panel

of the ASR/EPS- 16 PLUS at a later time.

You should now be able to place your OEX-6sr on the velcro strips

and have it remain in position. We suggest cleaning the velcro

strips periodically to maintain a secure fit.

Rubber Feet and Velcro Mount

Here’s what you’ll need to get started:

l OEX-6sr Output Expander

Six foot connection cable (cable lengths of 10 feet or

longer may not give optimal results, and are not

recommended by ENSONIQ)

Four rubber feet (included)

Two strips of adhesive velcro (included)

It is also possible to mount the

OEX-6sr with a combination of

rubber feet and velcro. Apply

the rubber feet to the bottom

front of the

OEX-6sr

as shown

in the illustration.

Mark a location on the upper

right hand lip of the

ASR/

EPS-16 PLUS. This is

where your velcro will be

positioned (the velcro is

mounted horizontally in this application).

Place the “furry” side of the two adhesive velcro strips

(included) in the position marked by the masking tape.

Remember to remove the masking tape and discard. Then

place the “hook” side of the two velcro strips on the bottom

of the OEX-6sr. Use your thumb to apply pressure to all

velcro strips to ensure a secure fit.

1 2 3 4 5 6 7 8 9 ... 20 21

No comments

ENSONIQ OEX-6sr User Manual Page 4