ENSONIQ DP/2 Specifications download pdf (Page 125)

Section 3 — Config Parameters

4 ENSONIQ DP/4+ Reference Manual

Selecting a Config Preset

In Select mode, you can select Config presets which will:

• Reconfigure the DP/4+ inputs and outputs;

• Change the signal routing between units; and

• Load a new algorithm (and its saved parameters) into each of the four Units.

To select a Config preset:

1. Press {SELECT}, then {CONFIG}.

2. Move the Data Entry Knob. The Select LED flashes, indicating that you are previewing

presets. The display shows the available Config presets.

3. When the display is showing the preset you want to load, press {SELECT} again. This selects

the preset, and the Select LED stops flashing (solidly lit).

Editing a Config Preset

In Edit mode, you can select between the input configurations and edit their related parameters

(which contain other signal routing information) using the {<} and {>} buttons to select

parameters, and the Data Entry Knob to change the value of the active (flashing) parameter.

To edit a Config Preset:

1. Press the {EDIT} button.

2. If the yellow Config LED is not already on, press {CONFIG}. The display shows:

Parameter Number Input Config Select (flashing)

m m

1 Source Config

1,2 > ABCD

The red LED display should indicate parameter 00, which is the Input Config Select parameter,

and the current config type should be flashing in the upper line of the LCD display (if not,

press {<} until this is the case).

3. If you move the Data Entry Knob now, you will select among the config types. There are

four different types of configs that can be edited:

1 source Config 2 source Config 3 source Config 4 source Config

When you stop moving the knob, the display momentarily shows:

Updating

Config

The DP/4+ is now updated into the config showing on the display.

4. To edit the remaining config parameters, press the {>} button to scroll to other parameters,

and move the Data Entry Knob to change their values.

Note: Changing the config type, or editing some config parameters may cause a brief

interruption in the audio output. This will happen if you change the number of

sources, or if the mono/stereo output routing is different. This interruption is normal

and is required for the system to reconfigure its signal routing.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 198 199

No comments

ENSONIQ DP/2 Specifications Page 125