ENSONIQ DP/2 Specifications download pdf (Page 41)

Section 1 — Controls & Basic Functions

ENSONIQ DP/4+ Reference Manual 25

Bypassing Units

At some point while you’re selecting various 4 Unit Presets, you may want to listen to how an

individual unit’s effect is processing the incoming audio signal. In this case, you would need to

bypass the other three units.

To bypass a single unit’s algorithm:

1. Press the unit button ({A}, {B}, {C}, or {D}) that you want to bypass.

2. Press the same unit button again. The red LED above the unit button will be lit, and the unit

will be bypassed.

3. Further presses of the unit button will toggle out of and into bypass.

To completely bypass all of the unit algorithms:

1. Press the {CONFIG} button.

2. Press the {CONFIG} button again. All of the red LEDs above the units will be lit, and the

units will be bypassed.

3. Further presses of the {CONFIG} button will toggle all four units out of and into bypass.

Refer to the description of the Bypass/Kill parameter in Section 3 — Config Parameters for more

information.

Note: Units can also be bypassed, un-bypassed, and killed remotely with MIDI

Program Changes by enabling the unit’s MIDI Program Change Map. See Section 4 —

System•MIDI for more information.

Quick Tips and Shortcuts

Here are a few quick tips to find your way around the DP/4+.

Tip: To get to the Algorithm Select parameter in Edit mode without having to scroll

through lots of parameters, while holding down either the {<} or {>} button, press

{CANCEL}.

Tip: When there are several parameters on the screen at one time, and you want to get

to the next screen without having to cursor through each parameter, while holding

down either the {<} or {>} button, press the other arrow button.

Tip: While holding down either the {<} or {>} button, turn the Data Entry Knob.

This lets you move much more quickly through a long list of parameters that by

repeatedly pressing the arrow buttons.

Tip: To return the last parameter you edited to its original value, press the {CANCEL}

button. This will only work as long as you still have that parameter selected. If you have

scrolled to another parameter, this undo function will no longer work.

Tip: If you accidentally change the algorithm in a unit, you will lose all of the

parameter settings for the old algorithm unless you press {CANCEL} to recall the

original algorithm and its parameters. You must press {CANCEL} before scrolling to

another parameter or leaving Edit mode.

Tip: If you double-click on the {CANCEL} button, a signed parameter (one that has a

range of -99 to +99) will put the level to +00 (the center position).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 198 199

No comments

ENSONIQ DP/2 Specifications Page 41