ENSONIQ DP/2 Specifications download pdf (Page 142)

Section 5 — Storage

ENSONIQ DP/4+ Reference Manual 7

Copying Presets

The DP/4+ can also copy presets to other RAM locations.

To Copy a Preset

1. Press {SELECT} (the Select LED should be on).

2. Press the {COPY} button. The top line of the display shows one of four possible screens:

Copy to 1U Pset Copy to 4U Pset

This shows that you are copying a 1 Unit Preset. This shows that you are copying a 4 Unit Preset.

Copy to 2U Pset Copy to Config

This shows that you are copying a 2 Unit Preset. This shows that you are copying a Config Preset.

The screen that appears and the type of preset that will be copied is determined by the

current config and the unit that is active when you press {COPY}. The rules which govern

this are the same as in Select mode. You can copy what you have most recently selected in

the current config.

3. Press {CANCEL} if you wish to exit from the copy procedure and return to Select mode. This

may be necessary if the preset type is not what you expected to copy. Make sure that the

Config LED is not on unless you wish to copy a config preset.

4. Use the Data Entry Knob to choose a new location (preset numbers 00 through 49) to copy

your preset. The LED numeric display shows the destination number for your preset.

5. Press the {COPY} button a second time to copy your preset. The display will momentarily

show the same “*WRITE OK*” message that appears when saving a preset from Edit mode

(see earlier).

6. You have just successfully copied your preset.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 198 199

No comments

ENSONIQ DP/2 Specifications Page 142