Part # 9310 0177 01 - B Model # MM-86
Drum Kit—General Purpose Reverbs
Small Plate Rev
#53
0276
E
EF
02765 762765
EF
Hall Reverb
#52
This Quick-Start describes how to set up the DP/2 as two complementary drum kit reverb devices, fed by two separate effect
sends from your mixing console. Try using send 1 for your bass drum and cymbals (including the hihat), and send 2 for your
snare and toms.
1. Connect your mixer’s two effect sends to the DP/2’s rear-panel Input 1 and 2 jacks.
2. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to the effect returns—or faders, if you like—on your
mixer. If you’ve only got one return (or fader), use Output 1 (and leave 2 unplugged).
3. While sending drum sounds through the two effect sends, turn the DP/2’s input knobs clockwise until the red peak LEDs
just above them are flashing occasionally.
4. Turn the outputs knob up until your mixer is receiving the proper level from the DP/2.
5. Press the {SYSTEM/MIDI} button. Press the{>} button until the large red number reads “46.” Use the data entry knob to
dial in “Set All 1U Pset Mixes To Wet=Yes.”
6. Press the {EDIT} button, and then the {CONFIG} button.
7. Press the {<} button until the large red numbers read “00.” Dial in “2 Source Config.”
8. Press {>} once. Use the data entry knob to set the AB Output Select to “Mixed Stereo.”
9. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “k” (if “k” isn’t already
displayed). Press {>} again to do the same for Unit B.
10. Press the {A} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Use the data
entry knob to dial in #53, Small Plate Rev—the “53” will start flashing.
11. Press the {B} button. If its red LED is flashing, press it again. Press {<} until the red numbers are flashing. Dial in #52,
Hall Reverb. In a moment, the “52” will begin to flash.
12. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
13. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its
parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust
how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red
LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same
thing—see the “Using Foot Switches” Quick-Start for details.
Comments to this Manuals