Part # 9310 0188 01 - A Model # MM-87
Voice-Over with Music Bed
Ducker & EQ
Config Preset 89
0276
E
EF
02765 762765
EF
With this Quick-Start, the DP/2 senses the presence of a voice-over announcer and automatically turns the music bed down
when he/she is speaking.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Connect your music source to the DP/2’s rear-panel Input 1 jack. Don’t send the music to your mixer—the DP/2 will take
care of that.
3. For the voice-over, plug a microphone’s effect send from your mixer into the DP/2’s rear-panel Input 2 jack.
4. Connect the DP/2’s Output 1 to an input on your mixer.
5. While playing your music bed, turn up the input 1 knob until the red peak LEDs above it is flashing occasionally.
6. Running the voice-over through the effect send, do the same with input 2.
7. Turn the outputs knob up until your mixer is receiving the proper level from the DP/2.
8. Press the {SELECT} button, and then the {CONFIG} button. If the red LEDs in the {A} or {B} buttons light up, press
{CONFIG} again.
9. Use the data entry knob to dial in #89, Ducker & Gate.
10. Press {SELECT} again.
11. Press the {EDIT} button, and then the {A} button.
12. Press {>} until “Ducker Output Mix” is displayed and “40” is flashing. Dial in a value of 00.
13. Press {>} until “Threshold” is displayed and “-30” is flashing. Dial in a value of -36.
14. Press {>} until “Release” is displayed and “90ms” is flashing. Dial in a value of 200ms.
15. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
16. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: Use your mixer to adjust the volume balance between the voice-over and the music.
Comments to this Manuals