Part # 9310 0177 01 - B Model # MM-86
MC Effects
Flanger Reverb
#75
0276
E
EF
02765 762765
EF
Pitch Shifter
#97
+
This Quick-Start provides MC’s and deejays with some special effects. There’s a flanger to make you sound like an alien and
a pitch shifter to send your voice way down into the basement.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Plug a microphone’s effect send from your mixer into the DP/2’s rear-panel Input 1 jack.
3. Connect cables from the DP/2’s back-panel Output 1 jack to an input on your mixing console or stereo amplifier.
4. While speaking, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.
5. Turn the outputs knob up until your mixer (or amp) is receiving the proper level from the DP/2.
6. Set your mixer so that you’re only hearing the output of the DP/2, and none of the original “dry” microphone signal.
7. Press the {EDIT} button, and then the {CONFIG} button.
8. Press the {<} button until parameter 00 is displayed in large red numbers.
9. Use the data entry knob to set the DP/2 to “1 Source Config.”
10. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
11. Press {>} once. Set the AB Unit Routing to “parallel.”
12. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already
displayed). Press {>} again to do the same for Unit B.
13. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Use the data entry
knob to dial in #75, Flanger-Reverb. In a moment, the “75” will start flashing.
14. Press the {B} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #97, Pitch
Shifter—the “97” will begin to flash.
15. Press the button once so that the “40” in “Mix=40” is flashing. Dial in a value of 99.
16. Use the {>}button and data entry knob to set PitchShifter Vc1 Fine to -02, PitchShifter Vc2 Semi to -05 and PitchShifter
Vc2 Fine to +02.
17. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
18. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: You can press the {A} or {B} buttons to turn off either of the processors (its red LED will light). Press again
to turn it back on (the red light will go out). Footswitches can accomplish the same thing—see the “Using Foot
Switches” Quick-Start for details.
Comments to this Manuals