Part # 9310 0188 01 - A Model # MM-87
Electric Guitar—Chorused
8 Voice Chorus
#65
0276
E
EF
02765 762765
EF
Large Plate Rev
#54
~
This Quick-Start sends your guitar through a rich chorus effect and then on to a large, clear reverb.
1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).
2. Plug your guitar cord into the DP/2’s front-panel input 1 jack.
3. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two inputs on your stereo guitar amplifier or mixing
console. If you’re going into a single-input guitar amp (or mixer), connect a cable from the DP/2’s Output 1 to that input.
4. While playing your guitar, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.
5. Turn the outputs knob up until your amp (or mixer) is receiving the proper level from the DP/2.
6. Press the {EDIT} button, and then the {CONFIG} button.
7. Press the {<} button until parameter 00 is displayed in large red numbers.
8. Use the data entry knob to set the DP/2 to “1 Source Config.”
9. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”
10. Press {>} once. Set the AB Unit Routing to “serial.”
11. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already
displayed). Press {>} again to do the same for Unit B.
12. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Use the data entry
knob to dial in #65, 8 Voice Chorus. In a moment, the “65” will start flashing.
13. Press {>} until the “00” in “Rate=00” is flashing. Dial in a value of 02.
14. Press the {B} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #54, Large
Plate. In a moment, the “54” will begin to flash.
15. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s
memory. Press {WRITE} again.
16. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the
character you want. When you’re done, press {WRITE} again.
Tip: To customize any of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its parameters;
use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust how much of
it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red LED will flash).
Press again to turn it back on (the red light will go out). Footswitches can accomplish the same thing—see the
“Using Foot Switches” Quick-Start for details.
Comments to this Manuals