Part # 9310 0177 01 - B Model # MM-86
Using Foot Switches
The DP/2 allows you to use the ENSONIQ SW-10 Dual Foot Switch to turn the DP/2’s two effects processors on and off.
To set up your foot pedal:
1. Connect the foot pedal to the Foot Switch 1 jack on the DP/2’s back panel.
1169+6%*
Eg
1169+6%*
Eg
2. Press the {SYSTEM/MIDI} button on the DP/2’s front panel.
3. Press the {<} or {>} button until the large red number reads “06” and the top line of the display shows “Unit A Bypass=.”
4. Turn the data entry knob to dial in “Ftsw 1-L Toggle.”
5. Press {>} until the red number shows “13” and the display reads “Unit B Bypass=.” Dial in “Ftsw 1-R Toggle.”
Each foot pedal is now assigned to its own processor:
674050+6
10#0&1((
674050+6
10#0&1((
Note: Whether it’s the effect being switched on and off—or the sound itself—is determined by each Unit’s
“(b)ypass and (k)ill” setting. See the description of the Bypass/Kill parameter in Section 3—Config Parameters in
the DP/2 Reference Manual.
Comments to this Manuals