ENSONIQ DP/2 Specifications download pdf (Page 59)

Part # 9310 0177 01 - B Model # MM-86

Electric Bass—Rock



EQ-Compressor

#86.

0276

02765 762765



Guitar Amp 4

#55.



This Quick-Start provides a compressor and an amplifier simulation for studio bassists.

1. Turn the DP/2 inputs and outputs knobs down all the way (counter-clockwise).

2. Plug your bass into the DP/2’s front-panel input 1 jack.

3. Connect cables from the DP/2’s back-panel Output 1 and 2 jacks to two inputs on your stereo bass amplifier or mixing

console. If you’re going into a single-input bass amp or mixer, connect a cable from the DP/2’s Output 1 to that input.

4. While playing your bass, turn the input 1 knob clockwise until the red peak LED just above it is flashing occasionally.

5. Turn the outputs knob up until your amp (or mixer) is receiving the proper level from the DP/2.

6. Press the {EDIT} button, and then the {CONFIG} button.

7. Press the {<} button until the large red numbers read “00.”

8. Use the data entry knob to set the DP/2 to “1 Source Config.”

9. Press {>} once. Use the data entry knob to set the AB Input Select to “mono.”

10. Press {>} once. Set the AB Unit Routing to “serial.”

11. Press {>} until “(b)ypass (k)ill” is displayed, and the letter following “A=“ is flashing. Dial in the letter “b” (if “b” isn’t already

displayed). Press {>} again to do the same for Unit B.

12. Press the {A} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Use the data entry

knob to dial in #86., EQ-Compressor. (This will be the second #86 you encounter, and will have a small dot to the right of

the numeral.) In a moment, the “86.” will start flashing.

13. Press the {B} button. If its red LED is on, press it again. Press {<} until the red numbers are flashing. Dial in #55., Guitar

Amp 4. (This will be the second #55 you encounter, and will have a small dot to the right of the numeral.) In a moment,

the “55.” will begin to flash.

14. Press {>} until “Amp PreampGain=30” is displayed. Dial in a value of “+15.”

15. To save the set-up, press {CONFIG}. Press {WRITE}. Use the data entry knob to select a location in the DP/2’s

memory. Press {WRITE} again.

16. Name your set-up by using the {>} and {<} buttons to underline each character, and the data entry knob to dial in the

character you want. When you’re done, press {WRITE} again.

Tip: To customize either of the effects, press {EDIT}, the appropriate letter and {>} or {<} to select its

parameters; use the data entry knob to edit them. You can change the “Volume=“ parameter in an effect to adjust

how much of it you’ll hear. You can also press the {A} or {B} buttons to turn off either of the processors (its red

LED will flash). Press again to turn it back on (the red light will go out). Footswitches can accomplish the same

thing—see the “Using Foot Switches” Quick-Start for details.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 81 82

No comments

ENSONIQ DP/2 Specifications Page 59