ENSONIQ TS-10 Specifications download pdf (Page 105)

Section 7 — Effect Parameters TS-10 Musician’s Manual

• Voices assigned to FX1 (and panned right) are sent to Effect B (PHLANGR)

• Voices assigned to FX2 are sent to the reverb (REV)

SENDS A- -B Range: 00 to 99

Controls the amount of Effect A (DDL) being sent into Effect B (the phlanger). A setting of 99

would yield a serial connection between Effect A and the PHLANGR for voices sent to FX1 and

panned hard left (on the Output page).

B- -REVRB Range: 00 to 99

Controls the amount of Effect B (PHLANGR) being sent into the reverb. This would allow you to

add reverb to voices assigned to FX1 and panned hard right. A setting of 99 would yield a serial

connection between the PHLANGR and the reverb for voices sent to FX1 and panned hard right

(on the Output page).

A- -REVRB Range: 00 to 99

Controls the amount of Effect A (DDL) being sent into the reverb. This would allow you to add

reverb to voices assigned to FX1 and panned hard left, without having to add any

phasing/flanging.

FX2- -REVRB PAN

DRY DDL REGEN L

DDL MIX DAMPING

LEVEL DELAY TIME L and R

For a complete description of these parameters, refer to the DDL+CHORUS+REV algorithm

found earlier in this section.

PHLNGR MIX Range: -99 to +99

Controls the Dry/Wet mix within the phlanger itself.

LEVEL Range: 00 to 99

Adjusts the volume of the phlanger signal. A level of 00 will offer no audible signal.

PAN Range: -99 to +99

Determines the location of the phlanger signal in the stereo spectrum. A value of -99 is panned

hard left, and +99 is hard right.

RATE Range: 000 to 127

Controls the rates of modulation of the phlanger.

REGEN Range: -99 to +99

Controls the amount of feedback applied to the phlanger. The sign of the value determines the

polarity of the feedback.

PHASE CENTER Range: -127 to +127

Controls the center of the phaser width.

WIDTH Range: 000 to 127

Controls the amount of modulation applied to phaser poles.

FLANGER CENTER Range: 000 to 127

Controls the center of the flanger width.

WIDTH Range: 000 to 127

Controls the range of the high to low-frequency sweep in the flanger effect.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 105