ENSONIQ TS-10 Specifications download pdf (Page 321)

TS-10 Musician’s Manual Section 14 — Understanding Sampled Sounds

Here you can select which BankSet you want to load your Sampled Sound into (BankSet 9 is

only available with expansion SIMMs installed) by using the data entry controls. The bottom

left corner of the display shows the amount of free (unused) blocks available in DRAM for the

currently displayed BankSet. As it comes from the factory, the TS-10 has 4018 blocks of free

DRAM memory. With expansion SIMMs installed, the TS-10 will offer 8114 blocks of DRAM

memory in BankSet S8, and 8191 in BankSet S9.

8) Press any Bank button (0-9) to load the Sampled Sound into the TS-10.

Multi-Disk Sampled Sound Display Messages

Multi-disk Sampled Sounds are loaded the same way as single-disk Sampled Sounds, with the

addition of a few extra display messages. Multi-disk EPS/EPS-16 PLUS/ASR-10 Sampled Sound

files are indicated by a flashing number next to the file name on the LOAD FILE page. After

loading part of a multi-disk Sampled Sound file, the display will read:

The next higher number

Sampled Sound file name

• If you answer YES to loading the next higher part number, with a disk containing the wrong

part number in the drive, the display will show DISK CONTAINS WRONG PART. This

message will last for a few seconds, and then return to the previous display.

• If you answer NO to loading the next higher part number, the display will momentarily show:

MULTI-DISK LOAD NOT COMPLETED.

• If you try to load part 2 without loading part 1 first, the display will momentarily show:

INVALID FILE LOAD PART 1 FIRST.

Selecting and Playing a Sampled Sound

Once the sound has finished loading, you will probably want to select it so you can play it:

• Press the Sounds button, press the BankSet button, and while holding it down, press the

Bank 8 button to select the Sampled Sound BankSet 8. You’ll find the display looks a bit

different than when you are selecting Programs:

Sampled Sound Status

Sampled Sound BankSet

Source Disk Name

Sampled Sound Bank

Sampled Sound File Name.

Press here to Select , or

double-click to Stack.

Press here to enter the

OPTIONS sub-page.

The top line of display shows the status of the Sampled Sound, and the name of the disk from

which the Sampled Sound was loaded into the TS-10. The bottom of the display also shows the

size of the Sampled Sound in blocks, the Sampled Sound name (or *EMPTY-BANK* for an empty

Sampled Sound bank location), and OPTIONS that provides access to an Options sub-page.

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 321