ENSONIQ TS-10 Specifications download pdf (Page 46)

TS-12 Musician’s Manual Section 2 — System Page Parameters

• PLAY/STOP — the Foot Switch will play and stop the sequencer, exactly reproducing the

actions of the Play and Stop buttons on the front panel.

• STOP/CONT — the Foot Switch will stop and continue the sequencer, exactly reproducing the

actions of the Stop/Continue button on the front panel.

• STEP-REC — this setting allows the Foot Switch to be used in Sequencer Step Entry record

mode to advance the track location by the amount set in the step size parameter on the Step

Entry page. This is the same as using the *STEP* command on that page.

• SONG-STEP — if a song step has been programmed with REPS=FS, each time you press the

Foot Switch, the TS-10 will select the sequence that is the next step in the song.

Tip: Both the Sustain and Sostenuto pedals can be used to dynamically “latch” the current amount of

pressure being exerted on the keyboard. Here’s how:

1) Select a sound that responds to pressure. Ideally choose a sustaining sound like an oboe.

2) Play a key and press into the keyboard until you can hear the pressure modulation affect the

sound of the note.

3) Press and hold the Sustain or Sostenuto pedal.

4) Release the key. You will hear that the sound continues to be modulated by pressure at the

depth to which you were pressing.

5) Play a different key. Notice that the new note is not modulated. You can now press into the

keyboard and modulate the new note independent of the note that is sustained. When the

current pressure output exceeds the latched level, pressure on the new note will modulate

both notes.

6) To release the “latched” pressure value on the sustained note, either press the “latched” key

again, or release the Sustain or Sostenuto pedal.

PEDAL Range: VOL or MOD

Determines whether the optional CVP-1 foot pedal will act as a volume pedal or a modulator:

• VOL — will control the volume of the currently selected or stacked Track(s). Transmitted via

MIDI as Controller #7.

• MOD — will affect any modulation destination that has PEDAL assigned as a modulation

source. Transmitted via MIDI as Controller #4.

Press the System button again to show the third sub-page:

SLIDER Range: NORMAL, TIMBRE, or XCTRL

Determines whether the Data Entry Slider will act as the Timbre or XCTRL modulator while on

any Sounds or Presets bank page. This allows you to vary the Track Timbre or Track XCTRL

setting of the primary selected sound without having to switch to the Timbre or XCTRL Track

Parameter pages. Refer to Section 5 — Preset/Track Parameters for more information about the

Timbre modulator.

• NORMAL — the Data Entry Slider will act normally, and will be disabled while on any

Sounds or Presets bank page.

• TIMBRE — the Data Entry Slider will control the Track Timbre setting of the primary selected

sound while any Sounds or Presets bank page is displayed. As a performance controller, the

slider will only affect the primary sound.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 46