ENSONIQ TS-10 Specifications download pdf (Page 204)

Section 10 — Understanding the Sequencer TS-10 Musician’s Manual

Important:

In Sequencer mode, selecting and editing a track from a Track Parameter page does not change

what is selected or layered on the Seq/Song Tracks 1-6 and 7-12 pages — i.e. it does not affect

what you hear when you play the keyboard. This means that you can edit a track parameter value

for one (or more) of the tracks within a group of layered sounds without changing the layer.

You can adjust volume, pan, timbre, etc. for tracks other than the selected track while playing

back a sequence. However, this also means that you could edit a performance value for a track

that you are not currently hearing from the keyboard, so be careful that you know what track(s)

you are listening to in relation to what is selected on the Track Parameter pages.

The track that is selected on the Seq/Song Tracks 1-6 or 7-12 pages is the one that will be

recorded if you go into record.

You should get in the habit of always selecting a track from the Seq/Song Tracks 1-6 or 7-12 page before

going into record.

The Tempo Track and the Track Parameters

Note that the Tempo Track feature offers no Track Parameter values, and appears on all of the

track parameter pages as TEMPO. For example, the Track Parameters Mix page would look

something like this:

Copying a Preset into 3 Sequencer Tracks

You can copy the three tracks of a preset, with all Track Parameter settings preserved, into three

tracks of the current song or sequence. The preset will be copied whole into the three tracks on

the upper or lower line of either the Seq/Song Tracks 1-6 or the 7-12 page:

• Press Seq/Song Tracks 1-6 or 7-12 and select any of the tracks on the line (upper or lower) to

which you want to copy the preset.

• Press Preset and use the BankSet and Bank buttons to select the preset you want to copy.

• While holding down the Preset button, press the same Seq/Song Tracks 1-6 or 7-12 button as

you did in the first step. The preset tracks are copied into the upper or lower line of that half

of the TRAX page.

When you copy a preset into a sequence, the values of all the Track Parameters are copied.

However, the selected and layered status of the tracks in the preset is not copied. Whichever

tracks in the sequence are selected or layered when the preset is copied will remain so after it is

copied. This also does not affect the track data in the sequence. The sequencer can only record

one track at a time (except in Multi-Track Record, described later in this section). If you want the

preset to play a sequence track, you must copy the sequence data to the other two tracks, if

needed.

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 204