ENSONIQ TS-10 Specifications download pdf (Page 175)

Section 9 — Program Parameters TS-10 Musician’s Manual

For the first thirteen wave classes, the bottom line of the display shows:

MULTISAMPLE-SHIFT Range: -60 to +60

Changes keyboard split points on multi-sampled waves. This has the effect of setting the

WaveSamples to ranges you wouldn’t otherwise hear (allowing aliasing in some cases), creating

completely different colorations. A setting of +00 is the default.

DIR Range: FORWARD or REVERSE

Any of the waves in these wave classes can be made to play forward (which is the normal mode)

or backward with this parameter. When DIR= REVERSE, the sound will play from the end of the

sample to the start point, and will not loop.

Press the Wave button again to get to the next Wave sub-page:

SAMPLE-START-OFFSET Range: 00 to 99

This controls where in the sample the wave will begin playing. When set to 00, the whole wave

will play. As the start point is adjusted upwards, it will begin playing further into the wave. You

can use this, for example, to skip the attack and play only the loop portion of looped (sustaining)

sounds.

Note: When using the INHARMONIC and WAVEFORM Wave Classes, this parameter will change the

starting phase, which is only heard when two waves are played at exactly the same pitch.

START-MODSRC Range: various

Here you choose which of the modulators will control the sample-start of the voice. Any of the

15 modulators can be selected.

MODAMT Range: -99 to +99

Determines how much the selected modulator (above) will affect the wave; i.e. how far away

from the start point the sound will move. If MODAMT=+00, the sound will remain static.

Positive amounts will modulate the sound forward (toward the end of the wave); negative

modulation amounts will move the sound back toward the beginning.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 175