ENSONIQ TS-10 Specifications download pdf (Page 337)

TS-10 Musician’s Manual Section 14 — Understanding Sampled Sounds

Lack of Memory Message

If you try loading a Sampled Sound and do not have enough free memory available, the

following display will appear:

At this point, you can select a loaded Sampled Sound Bank location to delete by pressing and

holding the appropriate Bank button. The display will show the name of the Sampled Sound in

that Bank location with the word *DELETE* flashing in the lower right corner of the display for

as long as the Bank button is held down:

flashing

While holding down a Bank button, if you press the soft button beneath *DELETE*, that

Sampled Sound Bank will be deleted. If the Sampled Sound Bank that you select to delete is

smaller than the SHORTAGE amount, the SHORTAGE amount will be adjusted, showing how

many blocks are still needed to load the Sampled Sound file. You may continue to erase Sampled

Sound Banks until there is enough free memory to load the Sampled Sound, at which point the

file will automatically load. Press the soft button beneath *EXIT* to abort the LOAD FILE

procedure.

Note that with expansion SIMMs installed (2x4 megabyte SIMMs), the two BankSets S8 and S9

are completely separate, and Sampled Sound memory blocks cannot overlap from one BankSet

into the other. The SHORTAGE value indicates the memory shortage in the BankSet that was

selected as the target for loading the Sampled Sound.

1 2 ... 332 333 334 335 336 337 338 339 340 341 342 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 337