ENSONIQ TS-10 Specifications download pdf (Page 10)

TS-10 Musician’s Manual Preface

Temperature Guidelines

The inner workings of the TS-10 contain a substantial amount of computerized and electronic

circuitry that can be susceptible to damage when exposed to extreme temperature changes.

When the TS-10 is brought inside after sitting in a cold climate (i.e. the back seat of your car),

condensation builds up on the internal circuitry in much the same way a pair of glasses fogs up

when you come inside on a cold day. If the unit is powered up as this condensation occurs,

components can short out or be damaged. Excessively high temperatures also pose a threat to the

unit, stressing both the internal circuits as well as the case. With this in mind, it is highly

advisable to follow these precautions when storing and setting up your TS-10:

• Avoid leaving the TS-10 in temperatures of less than 50 degrees Fahrenheit or more than 100

degrees Fahrenheit.

• When bringing the TS-10 indoors after travel, allow the unit at least twenty minutes to reach

room temperature before powering up. In the case of excessive outdoor temperatures (below

50 degrees Fahrenheit or above 100 degrees Fahrenheit), allow an hour or more before power

up.

• Avoid leaving the TS-10 inside a vehicle exposed to direct sunlight.

Amplification

Connect the Main Audio Outputs of the TS-10 to the line level inputs of a mixer, instrument

amplifier, stereo, or any other sound system, using 1/4 inch audio cables. For an additional set of

dry outputs, connect the AUX Outputs to two more mixer channels. If your system is stereo,

connect the Left and Right Main Outputs to two channels of your mixer, stereo, etc. If it’s mono,

use either of the Audio Outputs, but make sure nothing is plugged into the other output. For

listening through headphones, plug the phones into the rear-panel jack marked Phones. If you’re

running the TS-10 through a mixer, in stereo, be sure to pan the left mixer input fully left, and the

right input fully right.

TS▼10

It is a good idea to make sure your audio system is turned off (or down) when making

connections, to avoid damaging speakers or other components.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 10