ENSONIQ TS-10 Specifications download pdf (Page 126)

Section 8 — Understanding Programs TS-10 Musician’s Manual

Write Page — Saving a New Program Into Memory

Once you have modified an existing program or created an entirely new one, you can write or

save that program to any User RAM location using the Write Page. This page is also used to

rename the program with the name of your choice.

When you are ready to save a program into memory, first decide on a name of up to eleven

characters for your new program. Then:

• Press Write Program. The Write Program page appears as below, with the current program

name showing. You will see a cursor, or

underline

, beneath the first letter of that name.

• Edit the Program Name using the Data Entry Slider and the two Move Cursor soft buttons,

labeled LEFT and RIGHT. You can move the Data Entry Slider up and down to scroll

through the available characters, or step through them one at a time with the Up/Down Arrow

buttons. Find the first letter you want, then press the RIGHT button to move the cursor to the

next location. Repeat this procedure until the display shows the name you have chosen (or if

the KBD-NAMING parameter on the System page is ON, you can use the keyboard to enter

the name, as explained in Section 2 — System Page Parameters).

Tip: Moving the Data Entry Slider all the way down gives you a blank space. Also, using dashes,

periods and slashes between characters can make a sound name hold together better when

displayed on Program Bank and Preset pages.

• Select a memory location for your new program. Press one of the Bank buttons (0-9). As long

as you hold the button down, the display will show the sound select page for that bank, with

two differences:

1) None of the program names are underlined, and

2) the word “SAVE” is flashing in the lower left-hand corner, below the page name.

When you release the Bank button, the display will return to the Write page. Press another

Bank button and the display shows you the programs for that bank. To look at the Programs

in the other User RAM BankSet, simply press and hold down any of the ten Bank buttons as

before, and then press BankSet. You can also press the Bank buttons and the BankSet button

while holding down the Sounds button to “shop around” without returning to the Write page

each time you release the bank button.

• You may want to audition a few sounds before deciding which to replace. In this case, press

the soft button beneath the word *EXIT* on the display. This takes you off the Write Page.

Now use the Bank and BankSet buttons and the soft buttons in the usual way to select and

listen to the Programs in memory. Your new Program is still safe in the TS-10’s edit buffer.

Warning:

While you’re doing this, DO NOT use the data entry controls to change any parameters in the

programs you audition, as this would instantly replace your hard-earned new Program in the

Edit Buffer with something else entirely.

When you are through listening, return to the program you want to save by pressing the

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 371 372

No comments

ENSONIQ TS-10 Specifications Page 126