ENSONIQ TS-10 Specifications download pdf (Page 256)

Section 11 — Sequencer Parameters TS-10 Musician’s Manual

song and will enter Audition/Play mode.

• ADD — New data recorded into an existing track will be added to (or merged with) data

already in the track — the existing data will be left intact. Again, the sequencer will exit

record after one time through the sequence or song and enter Audition/Play.

• LOOPED — As with ADD mode, new data recorded into an existing track will be added to (or

merged with) data already in the track. However, when RECORD-MODE=LOOPED, the

sequencer will remain in Record for as many times as you play the song or sequence through

(rather than dropping out of Record after one time through). Think of this as “drum machine

mode” — as long as the sequence or song keeps playing, you can keep adding parts each time

around.

There is a fourth Record Mode which is available only when a song is selected:

• MIXDOWN — When a song is selected on the TS-10, you can set the Record Mode to

MIXDOWN, which is used to record dynamic Volume and Pan changes into sequence and

song tracks. When RECORD-MODE=MIXDOWN the TS-10 will record only changes made on

the Volume and Pan pages in the Track Parameters section. Notes, controllers, program

changes, etc. will not be recorded in this mode.

Depending on the setting of the EDIT TRACKS parameter on the next sub-page (see below)

you can mix down either the song tracks or sequence tracks over the length of the song.

TEMPO (Tap Tempo) Seq Range: 25 to 250 BPM, or EXT

Song Range: -64 to +63

Sets the tempo of the current sequence or song. On any of the three pages where tempo appears

(Click, Sequencer Control, and Locate), the soft button nearest the TEMPO field can be used to

“tap” in the tempo. If the field is already selected, tapping on the soft button at the correct rate

for the desired tempo (based on the metronome settings on the click page) will update the tempo

to the newest value. When CLOCK=MIDI, this field will read TEMPO=EXT to indicate that the

tempo is controlled by incoming MIDI clocks, and cannot be edited.

When a song is selected, the range is expressed as a percentage of the sequence tempo —

changing the song tempo offset automatically adjusts the tempo of each the sequences in the song

by a percent, within the legal limits of 25-250 BPM. When TEMPO=+00 the sequences in the song

will play at their designated tempo.

When a Song Tempo Track is selected, editing this value will record tempo change events.

AUTOPUNCH Range: OFF or ON

When overdubbing a track, this extremely powerful feature will automatically enter and exit

record mode at predetermined times which you specify. You can play along with the track and

have the TS-10 “punch” in and out for you like an invisible engineer. We refer to the points at

which recording will begin and end as the Edit Times and they are set on the second sub-page of

the Locate Page.

• ON — the TS-10 uses the Edit Times specified on the Locate sub-page for entering and exiting

record state.

• OFF — normal recording without using Edit Times.

LOOP Range: OFF or ON

This parameter controls whether or not the sequence or song will loop. The setting of this control

is remembered for each sequence and song.

• ON — the sequence or song will play continuously, looping back to the beginning when it

reaches the end.

• OFF — the song or sequence will not loop, it will play once and stop.

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 371 372

Comments to this Manuals

No comments

ENSONIQ TS-10 Specifications Page 256

Comments to this Manuals

Related products and manuals for Synthesizer ENSONIQ TS-10