ENSONIQ TS-10 Specifications download pdf (Page 95)

Section 6 — Understanding Effects TS-10 Musician’s Manual

Modulators that can be applied to the Effects

The following modulation sources are available to alter the effects in performance:

Mod Source

Modulation effect derived from

WHEEL the value of the mod wheel

PBEND the value of the pitch wheel

PEDAL the value of the Pedal•CV input

TIMBR the value of the TIMBRE parameter for the track

XCTRL the value of the XCTRL (external MIDI controller) parameter for the track

PRESS the channel pressure value for the track

KEYBD the number of the last key played

VELOC the average velocity of all keys played

KEYDN on when any keys are pressed; otherwise off

PATCH four values (0, 32, 64, 127) for the four button states

SUSTN on when the assigned foot switch is held down (and SUSTAIN is selected as a

FOOT-SW controller on the System sub-page); otherwise off

SOSTU on when the assigned foot switch is held down (and SOSTENUTO is selected as a

FOOT-SW controller on the System sub-page); otherwise off

FX-SW on when assigned foot switch is held down (and FX-SW-MOD is selected as a

FOOT-SW controller on the System sub-page); otherwise off

*OFF* no modulation

For more information about the Modulation Sources, see Section 8 — Understanding Programs.

DEST — Mod1 Destination Parameter Range: varies (selected parameter name)

DEST — Mod2 Destination Parameter Range: varies (selected parameter name)

The Destination parameters select which effect parameters will be modulated by the modulation

sources. The choice of parameters varies depending on the selected effect. Any parameter within

an algorithm can be selected. Each Effect Variation has a choice of two different mod

destinations. You cannot edit a parameter when it is assigned as a modulator destination.

Disabling modulation of a parameter will restore its saved value.

MIN — Mod 1 Param Range Minimum Range: varies (based on DEST parameter range)

MAX — Mod 1 Param Range Maximum Range: varies (based on DEST parameter range)

MIN — Mod 2 Param Range Minimum Range: varies (based on DEST parameter range)

MAX — Mod 2 Param Range Maximum Range: varies (based on DEST parameter range)

These four parameters set the minimum and maximum amount (based on the selected

Destination parameter’s range) that the Mod Destination will be modulated by the Mod Source.

Inverting the amounts will also invert the Mod effect.

Remember

In order for the effect modulation to work for the selected track, the Effect Mod Control

parameter on the Track Effects sub-page must be set to CNTRL-FX.

Note: When an effect algorithm parameter is selected to be modulated, that parameter can no longer be

edited. If you want to edit the parameter, set the Modulation Source (SRC) to *OFF*. To see the

current value that the modulator has set it to, reselect the parameter.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 371 372

Comments to this Manuals

No comments

ENSONIQ TS-10 Specifications Page 95

Comments to this Manuals

Related products and manuals for Synthesizer ENSONIQ TS-10